Guitar battery box install#
Guitar battery box professional#

Anything more than that is too much work for the cutter and will cause things to heat up too much. You are going to want each cut to take out another quarter of an inch.

When you drop in the bit for the router, slowly work clockwise around, enlarging the hole until eventually it reaches the edges of the template. Now so that we aren’t just trying to drop the router into the bass, we first drill a couple relief holes to get us started. If you have another template cut out of the same material, it’s nice to hold against the base of the router when you are adjusting the table on the router so you can see how deep the bit will be. It’s a good one to start with because it doesn’t need a lot of the bit buried into the wood in order for the bearing edge to read on the template. This particular is one will make a quarter inch depth cut. You can find them for sale at lutheir supply stores. We’re going to use a router with the standard bearing top router bit that luthiers usually use. Step three: Routing the battery box cavity We place it on where we want it, using our lines as guide, and press down firmly to make sure it stays in place. We put a strip on each side of the template to make sure it’s well adhered. We are going to be nice generous with this because we want to make sure our template stays in place. Take your time placing it exactly where you are going to want the battery box. Best Bass Gear sells templates made from clear acrylic which allows you to see your lines and to place it exactly where you want it. We make a mark at that point and use a protractor to draw a perpendicular line. After measuring we can see that our route needs to be about four and three-eighths inches from the butt of the guitar. In placing it I want to stay away from the area of the bridge and the pickups. This bass doesn’t have anything straight on its back, so we just eye ball it to give us something that looks right to work with. Since we are installing it in the center, start off with an approximate center line. That may work fine on a thick poly-finish, but it is a nice precaution to take if you have a delicate finish that may be damaged by pulling away tape. It also means we don’t have to adhere our tape directly to the finish of the bass. The transfer tape allows us to draw our layout on the instrument with pencil, which makes installation easier.

Guitar battery box professional#

You can pick some up from a vinyl sign professional in your area. Now we take a piece of vinyl transfer tape. This with make sure the double sided tape on our routing template does not come loose during routing. We use naptha which should remove any waxes or polishes that may have been used on the bass. The first thing we want to do is clean off the bass.

Guitar battery box install#

For this particular install we are going to install it in the center of the bass. When contemplating placement, you have a few different choices. (73mm) length X 1 11/32 in.Step one: Planning out battery box placement Electrical lead is NOT included with this battery box. The chamber that holds the battery is accessed by the tab that when open allows you to place the battery securely within the box and has foam attached to the inside lid to hold the battery firmly in place. depth minimum and holds a 9 volt battery flat on its side. The shallow mount battery box is designed to mount in a thin guitar body that requires a shallow battery box. A lead approximately 10 - 11 inches long is soldered in place to be wired into your harness. The chamber that holds the battery rotates by lifting the tab and then has a door that snaps in place to hold the battery securely within the box. The standard mount battery box is designed to mount in a guitar body that is able to be routed for 1 5/16 inches depth minimum and holds a 9 volt battery. Product Description WD® 9 Volt Battery Box Standard Mount: